How To Clean a Bathroom Exhaust Fan

Hither'southward the plan — don't neglect the fan.

Time

An hour or less

Complexity

Beginner

Price

Less than $xx

Introduction

That footling fan in the celling is more of import than you might think. It helps get rid of odors, airborne contaminants and moisture in the air. A fan covered in dust doesn't work efficiently, somewhen leading to mold, mildew and possibly a house fire. Requite it a skilful cleaning about every six months. Read on to discover out how to clean your bath frazzle fan.

Tools Required

Materials Required

  • Microfiber towel

Project step-past-footstep (5)

Step 1

Remove the Vent Cover

  • First, be sure the ability is turned off to the fan. To exist extra prophylactic, turn off the excursion at the breaker box.
  • If it'due south just a vent with no low-cal, remove the vent cover past gently pulling downwardly on information technology, then squeezing the metal mounting wires together on both sides. Slide them out of their slots, removing them from the fan housing.
  • If your vent cover has a calorie-free, disconnect the wire first. Printing the release tab on the connector before removing the cover.

exhaust fan open

Footstep 2

Clean the Vent Comprehend

  • Cleaning a cover without a light is simple. Fill up your bath sink with warm water and a few drops of dish soap. Soak the cover in the soapy water for a few minutes, and then scrub it with a cloth or castor. Identify the cover on a towel and allow it air dry out while you motility on to the next step — cleaning the fan.
  • If your fan cover has a light, do not submerge it in water . Only vacuum off the dust, wipe it make clean with a damp cloth, then air dry.

exhaust fan clean

Pace 3

Clean the Fan Without Removing the Motor

  • Utilise a vacuum with a crack attachment to remove most of the dust. Then switch to a brush attachment for the fan motor components and fan housing. Maintain a light touch so you don't impairment anything.
  • One time you remove the dry dust, take a damp microfiber cloth and wipe downwards the fan components and housing. This should remove any remaining dirt.

exhaust fan being vacuumed

Step 4

Remove the Motor for Deep Cleaning

  • Don't be afraid to further disassemble the fan. Depending on your brand and model, just two or iii screws hold the fan motor in the housing. (A magnetic tip screwdriver works well for this.)
  • To remove the fan motor, begin by unplugging the connector or plug that powers the fan.

exhaust fan

  • Next, remove the mounting screws that hold the motor to the housing. Remember to hold the motor with one hand while removing the last screw, and then lower the motor from the housing.

exhaust fan

  • Vacuum the motor and/or take it exterior and blow the grit from the motor and fan blades with forced air. A pocket-sized, soft bristle brush works well to remove caked-on dust.

Exhaust fan

  • Give the motor, fan blades and fan housing a good wipe down with a damp microfiber cloth before re-installing the motor back in the housing.

cleaning exhaust fan

Step 5

Reassemble the Exhaust Fan

  • With a make clean fan and a cover looking like new, it's fourth dimension to put the fan back together. If you removed the motor, your start step is to put information technology back in place and replace the screws.
  • Next, plug in the fan. Then put the cover dorsum on past inserting the mounting wires back into their slots, then gently pushing the cover into identify.

putting together clean exhaust fan